Unibrain Fire-i 580/780/785/980 Operation Manual Page 45
To utilize Auto-sync, please set Bit 31 to Auto-sync Enable, and then check the Bit 27 to verify whether it is ready.
Please refer to the details in the following table.
0xF2F10018
Auto-Sync Mode control register
Bit 31 : auto sync enable
Bit 30 : SIO enable mode (0 : custom mode, 1 : IIDC v1.32)
Bit 27 : auto sync complete (read only. 1: ready, 0: not yet auto-sync)
Read/Write
4.6. Memory Channel Save / Load
The settings of the camera features (Shutter, gain, etc.) and video modes can be stored in a non-volatile memory. The
camera supports 16 memory channels as per the table below to conveniently save and load different features as well
as video modes. Channel 0 is the factory default (preset) and Channels 1 ~ 4 can be used for saving camera
configuration. Channels 5 ~ 15 are used for resolution, mode and frame rate plus saving other features.
Address Name Bit Description
618h Memory_Save [0] Saves the current setting
[1..31] Reserved
Address Name Bit Description
620h Mem_Save_Ch [0] Factory Default Setting Cannot overwrite
[1..4] Write Channel for Memory Save for Channel 1 ~ 4
( Only for Features )
[5..15] Write Channel for Memory Save for Channel 5 ~ 15
(For Features, Format and Mode Save)
Address Name Bit Description
624h Cur_Save_Ch [0] Read and Load Factory Default Setting
[1..4] Read and Load Memory Channel 1 ~ 4
[5..15] Read and Load Load Memory Channel 5 ~ 15
User Defined FireWire Register Control
The values saved in the channel are users define; and can be made the default values at power-on. The channels
from 1 to 15 are to be set in the power-on default mode.
Address Description( bit : msb*) Read/Write
0xF2F1011C Power on default memory channel
Bit 0 ~ Bit 3 : power on initial memory channel
Read/Write
Example: Channel 5 is to be set the default mode at power-on.
add F2F1011C read -
50000000 write
