31
12.4.2. Audio input setting items
Use the Parameter setting knob for each parameter selection.
IN1– _______
Input channel name setting
The flashing portion is the cursor position for entering channel name characters.
Select a character from the alphanumeric character list by rotating the Parameter setting knob, then move the
cursor with the Right shift key.
Entering a new name overwrites the existing name, if there is.
To delete the character, select [ _ ] (under-bar) with the Parameter setting knob. Space cannot be entered.
Up to 7 characters can be used to set the name.
Even when an input channel name has been set, some setting screens display the channel number, not the
set name.
IN1– V
O
X –
O
FF
VOX ON/OFF setting (when the D-001T is used)
Set the voice operated exchange (VOX) to ON or OFF.
• ON: Activates the set Event only when the audio signals are input to the module.
• OFF: The VOX function does not work.
PREPA
G
ET
O
NE–
O
FF
Pre-paging tone ON/OFF setting (when the ZP-001T is used)
Set whether or not to sound a one-tone chime before paging.
Input Sensitivity setting (when the D-001T is used)
IN1– S
E
NS I T I V I TY– 10
Select the input sensitivity from the following 9 levels depending on the input sources:
7 characters (default: IN1 – 8)
Setting Range
–60, –54, –48, –42, –36, –30, –24, –18, –10 dB (default)Setting Range
Phantom Power ON/OFF setting (when the D-001T is used)
IN1– PHAN
TO
M
–
O
FF
Set the Phantom power to ON or OFF.
• ON: Supplies the phantom power.
• OFF: Does not supply the phantom power.
ON, OFF (default)
Setting Range
ON, OFF (default)Setting Range
ON, OFF (default)Setting Range
