Fig. 11
4.2 Unloading the pistol
Put air pistol "On Safe" (See Step 2.1).
Open the slide (See Step 4.1).
Remove the pellet clip and close the slide. Using a ramrod,
gently push each pellet out of the pellet chamber.
IMPORTANT: Never use sharp metal tools to remove pellets.
Replace the empty pellet clip (ratchet teeth facing the rear sight)
in the pistol (See Fig. 10).
Close the slide by pushing it all the way back until it locks into
place (See Step 4.1 and Fig. 11).
Check to make sure the barrel is completely unloaded by
pointing the muzzle in a SAFE DIRECTION,
taking "OFF SAFE" (See Step 2.2) and pulling the trigger to
fire. You may also unload your air pistol by
following the directions listed under Step 9 - Removing a
jammed pellet.
Fig.12
5. Safe aiming and shooting
NOTE: This air pistol will function in either "Double Action" or
"Single Action" mode. To fire in "Double Action", apply steady
pressure to the trigger until the pistol fires. "Single Action" mode
means that the internal striker has to be manually cocked prior to
firing. To use "Single Action" mode, grip the rear part of the slide
and pull it back, release it to allow it to move forward and squee-
ze the trigger (Fig.12). For rapid-fire shooting, we recommend
the "Double Action" mode, for more precise shooting, we recom-
mend the "Single Action" mode.
