I ,\
Terminal
To remove surface
unit, lift and pull
straight out.
Hold surface unit level
when replacing.
Push /
e
w
a
t
Lift
Removing surface units and reflector bowls:
1 First. be sure the Surface Unit Controls are all “OFF” and that the
surface units are cool.
2 See where the surface units plug into the range? Lift each surface
unit about an Inch (2 5 cm) at the edge away from the plug-in
(receptacle). Pull the unit strarght away from the plug-in. Do not
wash surface units; they will burn themselves clean during nor-
mal use.
3 L.ift out the reflector bowls
Replacing reflector bowls and surface units:
1 Be sure the surface unit controls are on “OFF.”
2 Put the reflector bowls back into their places Make sure you can see
!he plug-ins (receptacles) for the surface units through the square
hole in the side of each bowl and trim rings.
3 Hold the surface unit level with the prongs (terminals) pointing at
the plug-in.
4 With the prongs started in the plug-in start pushing In on the surface
unit At the same time. lift a little on the side of the surface unit that‘s
by the plug-in
5 Make sure the surface-unit prongs are pushed into the plug-in as far
as they will go. The surface unit ~111 fit Into the reflector bowl and be
level when everythrng has been done nght.
Removing and replacing upper oven rack guides:
L.ift the front of the rack gutde. Swing it away from the oven wall
fclr enough for the tab to get clear of the slot in the oven wall. Pull the
gr~!dt~ stralyht out of the oven To put it back. fit the end of the rack guide
111to thcl tivo holes In the back wall of the oven. Line up the tab on the
gu~clta wlttl t!re slot in the side small. Push it in and push down a little to lock
it ill place
15
