Setting Parameters in the Job Parameters Window 205
Print on back side: prints the last page of the job as the back cover
Print on both sides: prints the last two pages of the job as the back
cover
Finisher
The Finisher parameter enables you to select the destination of the printed
output.
¾ Select an Output Tray:
SCT (simple catch tray)
OCT (offset catch tray)
• The Offset check box is selected by default. If you don’t want
to use an offset between sets, clear this check box.
Top Tray
• The Offset check box is selected by default. If you don’t want
to use an offset between sets, clear this check box.
• To punch holes, select the Puncher check box, and select the
number of holes in the
Type list.
Stacker
• The Offset check box is not selected by default. If you want to
use an offset between sets, select this check box.
• To use staples, select the Stapler check box, and in the Position
list, select the staple position.
• To punch holes, select the Puncher check box, and select the
number of holes in the
Type list.
Booklet Maker
• To use staples, select the Stapler check box, and in the Position
list, select the staple position.
Note: The available stapling methods for PostScript files depend on the page
orientation and size. The stapling methods for PDF files depend on the page size.
