29
English
1
Set to the “
∞
” position.
2 Turn on the power.
3 Select main speakers A or B. The corresponding
indicator will be illuminated.
* Both speakers A and B can be selected.
4
Set to the “0” position.
5
Set to the “OFF ( )”.
6 Set the PARAMETER/SET MENU switch on the
remote controller to the PARAMETER position.
7 Press the TEST key on the remote controller so that
“TEST DOLBY SUR.” appears on the display to enter
the test mode.
This procedure lets you adjust the sound output level balance between the main, center, rear and front effect speakers using the
built-in test tone generator. After the adjustments, the sound output level heard at the listening position will be the same from each
speaker. This is important for the best performance of the digital sound field processor, the Dolby Digital decoder, the Dolby Pro
Logic Surround decoder and the DTS decoder.
The adjustment of each speaker output level should be done at your listening position with the remote controller.
Note: The cover of the remote controller must be open.
EXT. DEC.
