42
Tuning
BASIC OPERATION
1 Select “TUNER” as the input source.
2 Select the reception band. “FM” or “AM” will be
illuminated.
3
4 If “ : ” is illuminated on the display, press the
PRESET/TUNING button to turn it off.
5 Tune to the desired station manually.
* Hold down the button to continue the tuning search.
1 Select “TUNER” as the input source.
2 Select the reception band. “FM” or “AM” will be
illuminated.
3
4 If “ : ” is illuminated on the display, press the
PRESET/TUNING button to turn it off.
5 Press the side once to tune in to a higher
frequency.
Press the side once to tune in to a lower frequency.
* Press the button again if the tuning search does not stop at
the correct station.
* Use manual tuning if the tuning search does not stop at the
correct station because the signals are weak.
Quick automatic-search tuning (automatic tuning) is effective when the station signals are strong with no interference. However,
manual tuning can be used during less-than-ideal conditions.
Notes
●
Manually selecting an FM station will automatically change
the reception to monaural to increase the signal quality.
●
If an RDS station that employs PS data service is received,
its station name is shown on the display.
Ⅵ Automatic tuning Ⅵ Manual tuning
