94
EFFECT EDIT MODE
When Variation is set to Insertion:
NOTES
●
The Part to which Variation is applied is determined by the
Variation SendVariation Send
Variation SendVariation Send
Variation Send control in the Single Part controls (page 39).
●
As with System above, the effects cannot be properly heard unless the
Reverb Send, Chorus SendReverb Send, Chorus Send
Reverb Send, Chorus SendReverb Send, Chorus Send
Reverb Send, Chorus Send and
Variation SendVariation Send
Variation SendVariation Send
Variation Send parameters in the Single Part controls (pages 38,
39) and the
Reverb ReturnReverb Return
Reverb ReturnReverb Return
Reverb Return and
Chorus ReturnChorus Return
Chorus ReturnChorus Return
Chorus Return parameters in the All Parts controls are set to appropriate values.
●
The stereo position of the effects is controlled by the
Reverb PanReverb Pan
Reverb PanReverb Pan
Reverb Pan and
Chorus PanChorus Pan
Chorus PanChorus Pan
Chorus Pan parameters. (See pages 87, 88.)
●
You can set Reverb and Chorus to be routed in parallel or in serial, and you can determine the amount of Chorus that is sent to
Reverb. This is done with the
SendSend
SendSend
Send
Chorus to ReverbChorus to Reverb
Chorus to ReverbChorus to Reverb
Chorus to Reverb parameter (see page 89). When this is set to
00
00
0, Reverb and Chorus are in parallel routing. Higher values for each provide varying degrees of serial
routing.
VAR
Variation on/off
Pan
Volume Expression
Cho Send
Rev Send
Dry
Variation Part
Part1
Reverb Return
Chorus Return
Send Chorus to Reverb
Part16
DRY LINE
PAN
Reverb Pan
Chorus Pan
OUTPUT
Thick line indicates stereo signal.
CHORUS
The variation effect can be applied to only one Part at a time.
VARIATION CONNECTION = INSERTION
REVERB
Part2
Part3
SYSTEM EFFECT
Variation on/off
Volume Expression
Cho Send
Rev Send
Dry
Variation on/off
Volume Expression
Cho Send
Rev Send
Dry
Variation on/off
Volume Expression
Cho Send
Rev Send
Dry
VAR
VAR
VAR
Pan
Pan
Pan
PAN
