4-45
OIL FILTER ELEMENT AND WATER PUMP
INSTALLING THE RIGHT CRANKCASE
COVER
1. Install:
• Dowel pin "1"
• O-ring "2"
• Collar "3"
• Gasket "4"
Apply the lithium soap base grease on the O-
ring.
2. Install:
• Right crankcase cover "1"
•Bolt "2"
• Apply the engine oil on the impeller shaft end.
• When installing the crankcase cover onto the
crankcase, be sure that the impeller shaft end
"3" aligns with the balancer end slot "4".
• Tighten the bolts in stage, using a crisscross
pattern.
INSTALLING THE KICKSTARTER CRANK
1. Install:
• Kickstarter crank "1"
•Washer
• Bolt (kickstarter crank)
Install so that there is a clearance "a" of 8 mm
(0.31 in) or more between the kickstarter and
frame and that the kickstarter does not contact
the crankcase cover when it is pulled.
Bolt:
10 Nm (1.0 m•kg, 7.2 ft•lb)
Bolt (kickstarter crank):
33 Nm (3.3 m•kg, 24 ft•lb)
