ES-3124 User’s Guide
296 Chapter 37 Interface Commands
An example is shown next.
• Select ports 33-36 for internal loopback test.
• Execute the test command.
• View the results.
37.3 Interface no Command Examples
Similar to the no commands in the Enable and Config modes, the no commands for the
Interface sub mode also disable certain features. In this mode, however, this takes place on a
port by port basis.
37.3.1 no bandwidth-limit
You can disable bandwidth limit on port 1 simply by placing the no command in front of the
bandwidth-limit command.
Syntax:
no bandwidth-limit
An example is shown next:
• Disable bandwidth limit on port1
ras(config)# interface port-channel 33-44
ras(config-interface)# test 33-36
Testing internal loopback on port 33 :Passed!
Ethernet Port 33 Test ok.
Testing internal loopback on port 34 :Passed!
Ethernet Port 34 Test ok.
Testing internal loopback on port 35 :Passed!
Ethernet Port 35 Test ok.
Testing internal loopback on port 36 :Passed!
Ethernet Port 36 Test ok.
ras(config)# interface port-channel 1
ras(config-interface)# no bandwidth-limit
