Dimension ES-3024 Ethernet Switch
IEEE 802.1Q Tagged VLAN 23-5
ras> sys sw gvrp disable
This command turns off GVRP so that the switch does not propagate VLAN information to other switches.
23.4.6 VLAN1Q Port Status Command
Syntax:
ras> sys sw vlan1q port status <port>
This command shows information about the specified port’s VLAN settings.
The following example shows the settings for port 1.
Figure 23-7 VLAN1Q Port Status Command Example
23.4.7 VLAN1Q Port Default VID Command
Syntax:
ras> sys sw vlan1q port defaultVID <port> <VID>
where
<port> =
A port number
<VID> =
The VLAN ID. Valid parameter range = [1 – 4094].
This command sets a default VLAN ID for all untagged packets that come in through the specified port.
The following example sets the default VID of port 1 to 2000.
Figure 23-8 VLAN1Q Port Default VID Command Example
23.4.8 VLAN1Q Port Accept Command
Syntax:
ras> sys sw vlan1q port accept <port> <all|tagged>
where
<port> =
A port number
<all|tagged> =
Specifies all Ethernet frames (tagged and untagged) or only tagged
ras> sys sw vlan1q port status 1
Port 2 VLAN Setup :
Default VLAN ID = 1
VLAN Acceptable Type = Tagged Only
GVRP = Enable
ras> sys sw vlan1q port defaultVID 1 2000
