PES-1014 User’s Guide
4-8 System
FIELD DESCRIPTION EXAMPLE
The name is case sensitive and can be a maximum length
of 12 characters.
(default)
Community Indicates the name of the community that the management
host belongs to. See the previous figure or the top half of
the screen.
public
(default)
Status
Select either Enable or Disable to enable or disable the
SNMP management functions of each management host.
Enable
(default)
Click Apply to save your changes to working memory or click Reset to go to the previous configuration. Refer to
3.5.4 for directions on saving your changes to flash memory before you restart the switch.
4.7 Save Changes
Move the cursor over the System link and click Save Changes to display the Save Changes screen shown next. All
the settings mentioned above are stored only in working memory and are lost after the power is turned off. After
you configure settings, use the following procedure to store them:
Step 1.
Click Apply.
Step 6.
Click System in Information, and then Save Changes.
Step 2.
Click Save to save the settings into flash memory.
Restart the device (see 3.5.4) to store the settings in long term memory.
Figure 4-8 Save Changes
4.8 Firmware Upgrade
Use Internet Explorer 5.0 or later to upgrade the firmware.
Do not interrupt the upgrade process (interrupting it causes an error).
Restart the switch immediately after the upgrade is completed.
Move the cursor over the System link and click Software Upgrade to display the Firmware Upgrade screen
shown next.
• Download the new version firmware file through Internet by web browser or FTP.
