Filter
Top Products
1-221-22
1-221-22
1-22
Chapter 1: Product introductionChapter 1: Product introduction
Chapter 1: Product introductionChapter 1: Product introduction
Chapter 1: Product introduction
3.3.
3.3.
3.
IDE connectors (40-1 pin PRI_IDE, 40-1 pin SEC_IDE)IDE connectors (40-1 pin PRI_IDE, 40-1 pin SEC_IDE)
IDE connectors (40-1 pin PRI_IDE, 40-1 pin SEC_IDE)IDE connectors (40-1 pin PRI_IDE, 40-1 pin SEC_IDE)
IDE connectors (40-1 pin PRI_IDE, 40-1 pin SEC_IDE)
These connectors are for an Ultra DMA 133/100/66 signal cable. The
Ultra DMA 133/100/66 signal cable has three connectors: a blue
connector for the primary IDE connector on the motherboard, a black
connector for an Ultra DMA 133/100/66 IDE slave device (optical
drive/hard disk drive), and a gray connector for an Ultra DMA 133/
100/66 IDE master device (hard disk drive). If you install two hard disk
drives, you must configure the second drive as a slave device by setting
its jumper accordingly. Refer to the hard disk documentation for the
jumper settings.
• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
A8N-VM
®
A8N-VM IDE connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE
PIN 1
SEC_IDE