Filter
Top Products
E-52
4. Before using the cradle ports, remove the caps from the ports.
When using a LAN, connect one end of the LAN cable to the LAN port and the other end to
the PC or hub.
When using a USB connection, connect one end of the USB cable (DT-380USB) to the
USB port and the other end to the PC.
The USB host port is used for connecting the cradle with other USB peripheral device.
PC or hub
PC
5. Align the contacts on the bottom of the DT-X7 with the power contacts of the
Ethernet Cradle when inserting the unit.
The power LED on the front of the Ethernet Cradle will light green if the Handheld
Terminal has been properly mounted.
Status of Indicator 1 on DT-X7:
Orange: Charging the battery pack.
Red: Standby due to battery pack error or the surrounding temperature is out of the
charging temperature range.
(charging begins when the temperature is within the charging temperature range)
Green: Charging the battery pack is complete.
Important!
Always make sure to fi rst remove the Handheld Terminal from the Ethernet
Cradle when switching the selector switch.
Allowing the power contacts become wet can cause an electric shock or fi re. In
addition, if the contacts become soiled, contact may be impaired resulting in
poor charging. For reasons of safety and maintaining charging battery pack(s)
in optimum condition, clean the power contacts by wiping with a dry cloth or
cotton swab after disconnecting the AC adaptor.
Never short out the power contacts of the Ethernet Cradle. This can damage the
Ethernet Cradle.
Do not subject the Handheld Terminal and Ethernet Cradle to vibration or
impact during communication. This can cause communication to be interrupted.
•
•
•
•