Filter
Top Products
41
VX4500
40
VX4500
Adding a Pause to an Existing Number
1. Press Right Soft Key Contacts.
2. Use to highlight the Contact entry to edit, then press
.
3. Press Left Soft Key Edit.
4. Use to highlight the number then press .
5. Press Right Soft Key Pause.
6. Press Hard pause or 2-sec pause.
7. Enter additional number(s) and press .
8. Use to select the label type and press .
A confirmation message is displayed.
Contacts in Y
Contacts in Y
our Phone’
our Phone’
s Memor
s Memor
y
y
Phone Numbers With Pauses
When you call automated systems such as voice mail or credit
billing numbers, you often have to enter a series of numbers.
Instead of entering these numbers by hand, you can store the
numbers in your Contacts separated by special pause
characters (P, T). There are two different types of pauses you
can use when storing a number:
Hard pause (P)
The phone stops dialing until you press Left Soft Key Release
to advance to the next number.
2-sec pause (T)
The phone waits 2 seconds before sending the next string of digits.
Storing a Number With Pauses
1. Press Left Soft Key Menu.
2. Press Contacts.
3. Press New Number.
4. Enter the number.
5. Press Right Soft Key Pause.
6. Use to select pause type and press .
Hard Pause / 2-sec pause
7. Enter additional number(s) (e.g., pin number or credit card
number) and press .
8. Use to select a Label and press .
9. Enter a name (up to 22 characters).
A confirmation message is displayed.
VX4500-(E)Small (1.3).QXD 8/11/04 7:04 PM Page 40