Filter
Top Products
Get started
Install SIM card and battery
Always switch the device off and disconnect the charger
before removing the battery.
This phone is intended for use with a BL-4S battery. Always
use original Nokia batteries.
The SIM card and its contacts can be easily damaged by
scratches or bending, so be careful when handling, inserting,
or removing the card.
Before you can install or remove the SIM card, you must
remove the battery.
1. Push the back cover toward the top of the phone, and
remove it.
2. Remove the battery.
3. Insert the SIM card into the holder with the contact
surface facing down.
4. Observe the battery contacts, and insert the battery.
5. Replace the back cover.
Insert a memory card
Use only compatible microSD cards approved by Nokia for use
with this device. Nokia uses approved industry standards for
memory cards, but some brands may not be fully compatible
with this device. Incompatible cards may damage the card
and the device and corrupt data stored on the card.
Your phone supports microSD cards with a capacity of up to
8GB.
1. Open the memory card cover.
2. Insert the memory card into the
memory card slot with the
contact surface facing up, and
press it until it locks into place.
3. Close the memory card cover.
Remove the memory card
Important: Do not remove the memory card in the
middle of an operation when the card is being accessed.
Removing the card in the middle of an operation may damage
the memory card as well as the device, and data stored on
the card may be corrupted.
You can remove or replace the memory card during phone
operation without switching the device off.
© 2008 Nokia. All rights reserved. 11