Filter
Top Products
Charge the battery
Your battery has been partially charged at
the factory. If the device indicates a low
charge, do the following:
1 Connect the charger to a wall outlet.
2 Connect the charger to the device.
3 When the device indicates a full
charge, disconnect the charger from
the device, then from the wall outlet.
You can also charge the battery with a USB
cable, using power from a computer.
1 Connect the USB cable to a USB port of
a computer and to your device.
2 When the battery is fully charged,
disconnect the USB cable.
If the battery is completely discharged,
USB charging may not work. Use the
charger instead.
You do not need to charge the battery for
a specific length of time, and you can use
the device while it is charging. If the
battery is completely discharged, it may
take several minutes before the charging
indicator appears on the display or before
any calls can be made.
Charging the device while listening to the
radio may affect the quality of reception.
GSM antenna
Your device may have internal and
external antennas. Avoid touching the
antenna area unnecessarily while the
antenna is transmitting or receiving.
Contact with antennas affects the
communication quality and may cause a
higher power level during operation and
may reduce the battery life.
The figure shows the GSM antenna area
marked in grey.
Connect a headset
Warning:
When you use the headset, your ability to
hear outside sounds may be affected. Do
not use the headset where it can
endanger your safety.
When connecting any external device or
any headset, other than those approved
by Nokia for use with this device, to the
Nokia AV Connector, pay special attention
to volume levels.
Do not connect products that create an
output signal as this may cause damage
to the device. Do not connect any voltage
source to the Nokia AV Connector.
Get started 7
20
1
0
© Nokia. All rights reserved.