Filter
Top Products
E-18E-17
Open the Case.
Insert the buckle opener of the accessory into the buckle opening
lever as shown in the figure (in direction ) Pull the buckle opener
slowly (in direction ). When not using the buckle opener, hold the
buckle opening lever with your thumb and index finger from the side
and pull it up slowly.
: •
Be sure to turn the flash off before inserting it into this case.
•Do not apply excessive force to the flash when
inserting it.
• When removing the flash from this case, hold the
flash so as not to drop it.
CAUTION
: •
Insert the silica gel all the way at the specified location and
with the specified orientation. When the orientation is not
correct, the silica gel bag will be caught when the Case is
sealed and water leakage will be caused.
•
Attempting to seal the Case with the bag inserted only part of
the way will cause the silica gel bag to get caught by the O-ring
and water leakage will occur.
•
Once silica gel has been used, the moisture absorption
performance will be impaired. Always exchange the silica
gel when the Case is opened and closed.
CAUTION
Insertion of silica gel
Before closing the case, place the provided bag of silica gel (to
prevent fogging) between the right side panel of the flash and the
case. Insert the bag with the longer, glued side first.
Inserting the flash
Carefully insert the FL-20 Electronic Flash into the hot shoe of this
case. Make sure that the protruding part of the camera’s zoom
lever fits properly in the notch in case’s zoom lever.
Follow the steps shown in the illustration; insert the flash all the
way into the hot shoe; turn and tighten
the shoe lock dial of the flash.
To remove the FL-20 from this case, follow these steps; turn and
loosen the shoe lock dial of the flash; holding the flash’s dial
firmly with a finger, slide the case out of the flash’s hot shoe.
*PFL-01(E).qxd 03.11.27 3:14 PM ページ E-17 (1,1)