Filter
Top Products
E-18
Seal the Case.
Make sure the camera is loaded properly.
:•Seal the Case by turning both buckle lock levers down
in arrow direction. When one of the buckles is left
open, the Case will not be sealed and water leakage
will be caused.
CAUTION
Gently close the rear lid (so that the O-ring does not slip out of the
groove). Hook the buckle on the edge of the rear lid, and tilt the
buckle open/close lever in the direction of the arrow to hermetically
seal the Case.
Check the following points before sealing the Case.
ț Is the digital camera loaded properly?
ț Is silica gel inserted deep in the specified location?
ț Is the O-ring attached properly to the opening on the Case?
ț Is there any dirt or foreign matter on the O-ring or the O-ring contact
surface on the front lid?