Filter
Top Products
Setting the Handset and Base Unit
34
*
1
After you set the PBX type, disconnect and reconnect the telephone cord.
*
2
To check the type of PBX you are using, see page 30.
*
3
When a check mark is displayed beside a tone type, the incoming call log for that tone type
will be logged.
• These settings are only applied to your telephone, not the PBX itself.
Main Item Description Setting Default
Selects the type of PBX that
the base unit is connected to.*
1
Type 1*
2
Type 2
Type 1
When using a KX-TAW848/KX-
TDA series PBX, and the PT LED
patterns for FWD and DND have
been set reversely on the PBX, you
need to set Mode 2. (See
page 6.)
Mode 1
Mode 2
Mode 1
“
PBX Type-Type 1
(KX-TAW/TDA series)”
only
Selects which line of information is
displayed as Caller ID. When the
Caller ID matches an item stored in
the Phonebook, the handset rings
according to the setting of the item.
As shown below, a caller’s
number, caller’s name and CO line
number are displayed on each line.
Displayed items vary depending on
your PBX and its settings.
1st Line
2nd Line
3rd Line
1st Line
“
PBX Type-Type 2
(KX-TA308/TD
series)” only
Sets the current date and time
for the base unit.
Date
Time
01-01-05 (D-M-Y)
12:00 AM (H:M)
“
PBX Type-Type 2
(KX-TA308/TD
series)” only
Sets each type of Incoming
Call Log to either on or off.*
3
You must set at least one of the
incoming call types to on to
store a received call in the
Incoming Call Log.
Single Tone
On
Off
Double Tone
On
Off
Triple Tone
On
Off
Single Tone: Off
Double Tone: Off
Triple Tone: Off
PBX Type
Fwd/DND Icon
Caller ID Line
T.Edison
01234567890
LN-001:
1st Line
2nd Line
3rd Line
<Example>
Date&Time
Incoming Log