Filter
Top Products
11
English
KIT CONTENTS
Colour LCD screen
Installation cable
Electronic control unit
Directions for use
Fitting accessories
FITTING
First of all, choose the place for the colour screen inside your vehicle.
We would advise you to t it in the centre of the dashboard
or near you.
Make sure that you can view the screen at a good angle and that it does
not obstruct your view of the road. Once the hands-free kit is fully installed
and switched on, you can adjust the screen’s brightness.
The installation cable is tted with ISO connectors, as well as two line-out
jacks for connecting to the car stereo’s line-in jacks if applicable.
Car Stereo With line-in jaCkS:
Use this type of connection by wiring the brown and white wires
(or red and black) to the car stereo’s line-in jack and the yellow wire
to the car stereo’s mute jack.
Car Stereo With iSo ConneCtorS:
Disconnect the ISO connectors from your car stereo. Join the male ISO
connectors of the kit’s cable to the car stereo. Join the vehicle’s ISO
connectors to the female ISO connectors of the kit’s cable.
If the car stereo features a mute in jack, connect the yellow wire of the
kit’s cable to the corresponding «mute in» jack (Mute in 1, 2 or 3).
•
•
•
•
•
Car Stereo Without iSo ConneCtorS:
An adapter cable is required to convert the specic connections into
an ISO connector. As a result, installation will be the same as with
an ISO connector. Parrot offers a range of ISO adapter cables.
Visit our website at www.parrot.com.
Fitting the kit’S CaBle:
Check the wiring diagram for the car stereo’s ISO cable.
The red wire of the kit’s cable must be connected to the constant 12V
supply, the orange wire to the ignition 12V and the black wire to ground.
On some vehicles, the red and orange wires may need to be reversed.
This can easily be done by reversing the two fuse holders.
On other vehicles, the ignition 12V may be missing from the car stereo’s
connectors, meaning that you must connect the orange wire directly
to an available ignition 12V source in the vehicle.
Do not connect the orange wire to the constant 12V supply,
as you could run down the vehicle’s battery.
CheCking the inStallation:
If your Parrot 3200 LS-COLOR PLUS is correctly tted, you should see
the message «Goodbye» on the screen when you switch off your car’s
ignition.