Filter
Top Products
WAP 33
Configuring WAP parameters
Select the
Advanced…
menu, then the
configuration
menu.
Choose from the sub-menus offered:
Logon parameters
is used to select or modify your access provider's logon parameters or configure the parameters of other
access providers.
The active access service is preceded with a start.
Configuration of GSM and GPRS parameters (depending on model):
All information to be entered in the parameters are provided by your operator or access provider.
- Choose desired access service, then press
Choice
.
- Enter title of service and accept.
- Enter Internet address of home page and accept.
- Enter parameters of preferred logon:
• GPRS otherwise GSM
(by default): the logon to WAP services uses the GPRS as a priority. However, in the event of
unavailability of the GPRS network, the GSM network is used to establish the link.
• GPRS
: the logon to WAP services uses the GPRS network exclusively.
• GSM: the logon to WAP services uses the GSM network exclusively.
The
GSM parameters
to be entered are:
- User name
- Password
- IP address of WAP gateway
- Port type (secure or insecure)
- Call number
- Access mode (digital, analogue or automatic)
In automatic mode access can be gained to the operator's network by a digital link and by an analogue link to a different
network (in roaming).
The
GPRS parameters
to be entered are:
- User name
- Password
- IP address of WAP gateway
- Port type (secure or insecure)
- APN: if no APN has been defined, press the
right programmable key
[
Choice
] then the APN menu.
Select or add and APN.
251959374_myX2-2_lu_en.book Page 33 Mercredi, 30. mars 2005 11:48 11