Filter
Top Products
2827
MANAGING KEY ASSIGNMENTS
You can view station key assignments and add extenders to some of the pro-
grammable keys for easy one touch operation of frequently used features.
An extender is a number that makes an otherwise general key very specific.
Adding the digit “4” to a PAGE key defines this key for paging zone four.
Adding “225” to a directed pickup key will define this key as pickup for ex-
tension 225 only. The key must already be assigned by the installing techni-
cian.
Use this program to assign extenders to the following keys:
KEY DESCRIPTION EXTENDER
BOSS ........Boss/Secretary ....................(1–4)
DP ..............Direct Pickup ......................(Extension number or
station group number)
DS ..............Direct Station ......................(Any extension number)
FWRD ........Call Forwarding ..................(0–7)
GPIK ..........Group Pick-Up ....................(01–20)
IG ..............In/Out of Group ..................(Any group number you are part of)
MMPG........Meet Me Page ....................(0–9, ✱)
PAGE ........Page ....................................(0–9, ✱)
PARK ........Park (orbits)..........................(0–9)
RP ..............Ring Plan..............................(1–6), HOLD for none
SPD............Speed Dialing ......................(00–49, 500–999)
PMSG ........Programmed Messages ....(01–30)
DIR ............Directory ..............................PERS (1), SYS (2) or STN (3)
VT ..............Voice Mail Transfer ..............Voice Mail Group (501–549)
SG..............Station Group ......................500 or 5000 through 549 or 5049
PROGRAM KEYS
UP & DOWN - Select the extension number.
KEYPAD - Used to enter extender codes.
HOLD - Used to clear the displayed data.
Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press TRSF and then dial 107 [2
01] KEY EXTEND
Display shows the first station 01:CALL1
2. Dial the station number (e.g., 205) OR use [205] KEY EXTEND
UP or DOWN to scroll through the station 01:CALL1
numbers and press the right soft key to
move the cursor
3. Enter the key number (e.g., 18) OR use [205] KEY EXTEND
UP and DOWN to scroll through the keys 18:DS
and use the right soft key to move the
cursor OR press the key to be programmed
4. Dial the extender according to the list
above and the system will display your
selection
If there are no more entries, press
the left soft key to return to step 2
5. Press TRSF to store and exit programming [205] KEY EXTEND
OR press SPK to store and advance to the 18:DS207
next program