Filter
Top Products
Installation and Operation 7
Note: The telephone and telephone cord are not included. You must provide your own
telephone and telephone cord.
Note: The device and telephone cord are for indoor use only.
Note: Only telephones connected directly to the Sprint Phone Connect 2 will receive service. If
the Sprint Phone Connect 2 is connected to a cordless phone base station, any
extension phones compatible with that base station will also receive service.
Powering Sprint Phone Connect 2 On and Off
Use the power button to turn the Sprint Phone Connect 2 on and off.
► To power the device on, press and hold the button until power indicator turns on.
► To power the device off, press and hold the button until all indicators turn off.
Note: For the first time you use the Sprint Phone Connect 2, wait 3-5 minutes for activation to
finish or while LEDs are blinking green from right to left. Do not touch your Sprint Phone
Connect 2 during this time. If after 5 minutes the LED lights are still blinking, power cycle
your device using the power button.
Understanding the Indicators
The four LED lights on the front of your device let you know your device’s status at any given
time.
Light
Indicator
Meaning
Power
White The device is on
Battery
Solid Green Full Charge
Blinking Green Partial Charge
Blinking Red Low Charge
Solid Red No Battery Charge
Signal
Green With signal
Off Without signal
Signal Strength
Green Good or Ok
Red Poor or None
Voicemail
Blinking Green New Message
ALL LEDs
Blinking Green from Left to Right The software is being updated