Filter
Top Products
White Paper Z600
69 September 2003
WAP Operator technical data
Feature Support in the Z600 for WAP
WAP Browser
Version 2.0 baseline
HTML XHTML, mobile profile
WAP Provisioning
Total Parameter sets 5
Parameter set list Name
Startpage
IP settings:
CSD phone no., CSD Data rate, CSD dial type
GPRS APN, password request, allow calls, authentication,
data compression, header compression, quality of services
IP address, datamode (conn.less or oriented)
UserId and password
Security on/off
Show images on/off
Response timer
Manual selection Yes, between Analog (V32) and Digital (V110)
Parameter sets include WAP/CSD, WAP/GPRS (different sets)
Factory pre-configuration WAP/CSD (possibility to lock a setting), WAP/GPRS
OTA WAP/CSD, WAP/GPRS configuration possible
Simultaneous OTA WAP/CSD, WAP/GPRS configuration possible
Single OTA WAP/CSD, WAP/GPRS is not possible
Bookmarks Not empty by default
URL format Underlined
Security mechanism
OTA provisioning (if empty) Operator verification through a code, included in the OTA data.
This code is shown to the user who can choose installation or
not.
Interface (if empty) An Install question is asked with the code, if available.
The user has to choose if a new WAP profile shall be created or
an existing profile shall be replaced.
Re-provisioning (Set 1 filled) As above
Interface (Set 1 filled) As above
Carrier reset/provisioning Yes, but not if the set is pre-configured in the factory and locked.