Filter
Top Products
SpectraLink Corporation Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
9. Certifying the NetLink e340/i640 Wireless
Telephones
Conduct a preliminary Site Survey Mode test according to the directions given below.
Note any areas where coverage is conflicting or inadequate. Note any system difficulties
and work with your wireless LAN and/or LAN system administrator to determine the
cause and possible remedy. See the section Troubleshooting Wireless Telephone
Problems for clues to possible sources of difficulties.
9.1 Site Certification
The installer should not leave the site before performing installation verification.
These tests must be performed in typical operating conditions, especially if heavy loads
occur. Testing sequence and procedure is different for every installation. Generally, you
should organize the test according to area and volume, placing numerous calls to others
who can listen while you perform coverage tests. Note any areas with excessive static or
clarity problems and report it to Customer Service.
The coverage test will also require you to put the Wireless Telephone in
Site Survey
Mode and walk the entire coverage area to verify all access points.
The Wireless Telephone performing the site survey must be configured
for ESSID Learn Once or Static. Site survey mode is not available in
Learn Always.
The installation is not complete until these certification steps have been
performed. Do not hand out Wireless Telephones at a site that has not been
certified.
9.2 Site Survey Mode
Test signal strength in the covered area by performing a Site Survey. Put a Wireless
Telephone in Site Survey Mode (see NetLink e340/i640 Wireless Telephone
Configuration section) and walk the entire coverage area while viewing the display.
The
FCN key toggles between the three coverage modes described below. The Wireless
Telephone will remain in Site Survey mode until it is powered off. When testing is
complete, press
Power Off to power off the Wireless Telephone.
Numbers racing across the Wireless Telephone display indicate AP information is being
obtained. A
Waiting message indicates the system is not configured properly and the
Wireless Telephone cannot find any APs.
PN: 72-1084-02-D.doc Page 35