Installing and Configuring the Line Unit
10 May 29, 2002 Campus-RS Line Unit User Manual
Install the NID on the HDSL line between the HDSL jack and the Telephone
Company (Telco) demarcation point.
ADC also suggests providing power line protection for critical circuits in high
lightning areas. Use conditioned AC voltage, furnished through an
Uninterruptible Power Supply (UPS), that is bonded to a good facilities
ground. This provides additional protection against voltage transients
entering through the power lines.
INSTALL THE LINE UNIT
To install the Line Unit:
1 Install the interface card into the back of the Campus-Star chassis,
following the instructions in the User Manual for the card.
2 Ensure that the retaining latch is pulled completely forward and down.
Make sure you install the interface card before the line unit.
Installing the card with the line unit already installed may
cause damage to the card, the line unit, or both.
NID
HDSL line
Campus-RS Unit
HDSL line port
Telco demarcation point
HDSL
jack
1061.book Page 10 Wednesday, May 29, 2002 8:59 AM
