Installing and Configuring the Line Unit
14 May 29, 2002 Campus-RS Line Unit User Manual
Standard Mode Configuration
This section continues from Step 4 in the previous section to set a standard
HDSL transmission rate.
1 If the Operating Mode is set to STANDARD, skip to Step 3. Otherwise,
press Enter.
2 Press Next until STANDARD displays, then press Enter. The LCD
displays OPERATING MODE.
3 Press Next until HDSL RATE displays, then press Enter.
4 Press Next until the desired HDSL transmission rate displays, then
press Enter.
To continue setting up the system, proceed to the “Set the HDSL Transceiver
Mode” section.
Extended Mode Configuration
This section continues from Step 4 on page 13 to set an extended HDSL
transmission rate.
1 If the Operating Mode is set to EXTENDED, skip to Step 3. Otherwise,
press Enter.
2 Press Next until EXTENDED displays, then press Enter. The LCD
displays OPERATING MODE.
3 Press Next until LOOP MODE displays, then press Enter.
4 Press Next to display either 2 LOOPS or 1 LOOP, then press Enter to
select the option displayed. The LCD displays LOOP MODE.
5 Press Next until HDSL RATE displays, then press Enter.
6 Press Next until the desired HDSL transmission rate displays, then
press Enter.
To continue setting up the system, proceed to the “Set the HDSL Transceiver
Mode” section.
1061.book Page 14 Wednesday, May 29, 2002 8:59 AM
