Erasing the Search Band Channel Memory
The frequencies entered in Search Band Channel Memory can be erased.
1. Set the unit to the Channel Memory Mode by pressing 7 FREQ./CH while FUNC is pressed until ‘M’ appears on
the display.
2. Turn the selector to select the Channel Memory address of the search band that you wish to erase.
(Illust. 30-1)
3. Hold down FUNC key and press CLEAR PROGRAM key. (CLr is displayed.) (Illust. 30-2)
4. Hold down FUNC key and press CLEAR PROGRAM key once again. (A high pitched beep is emitted and the
Search Band Channel Memory is erased.)
5. To complete the procedure, press CLEAR PROGRAM key.
Note:
l To cancel the operation, press CLEAR PROGRAM key before Step 4.
l When one of the two frequencies that make up a set in Search Band Channel Memory is erased, the receiver
does not perform the search.
Searching a Specific Range (Program Search)
The range is determined by specifying two stored channel memory addresses. The program search starts between
these two channel frequencies.
Set the unit to the FREQ Mode by pressing CLEAR PROGRAM key .
Hold down FUNC key and press 7 FREQ/CH key. ‘M’ appears on the display.
Select the channel memory address to be set as one end of frequency limit. (Illust. 31-1)
Hold down FUNC key and press 3 SEARCH key. (Illust. 31-2)
Select a channel memory address to be set as the other end of frequency limit by using numeric keys.
(Search starts when 3rd digit is entered.)
To complete the procedure, press CLEAR PROGRAM key.
Skipping a Frequency During a Search [1] (Search Pass Channel Memory)
During a search, the unit may stop at the unwanted frequencies such as noise or blank carrier. These frequencies
can be programmed into Search Pass Channel Memories and the receiver allows you to search through the band
without stopping at these unwanted frequencies. 80 frequencies can be programmed in Search Pass Channel
Memory. The addresses of this channel memory allocated for Seach Pass are from P00 to P79. Search Pass
Channel Memory is entered during a search operation by the following procedure.
Confirm that the search is stopped on the unwanted frequency to be skipped or set at the unwanted frequency
by rotary selector. (Illust. 32)
Hold down FUNC key and press 9 L/OUT key.
( A high pitched beep is emitted and the frequency is stored in search pass channel memory.)
Note:
l If all 80 channels of Search Pass Memories are full, „Pin -“ is displayed and no frequencies can be
programmed into Search Pass Memory. In such a case, clear any of the frequencies programmed into Search
Pass Memory channels by entering corresponding 3-digit numbers of the channel that you wish to be erased.
The new unwanted frequencies is automatically rewritten into this channel.
l While in Channel Memory Mode (‘M’ appears on the display), by holding down FUNC key and pressing the 7
FREQ/CH key, the Search Pass Channel Memory displays. Change the channel Memory addresses using the
numeric keys, Selector, etc.
Erasing the Search Pass Channel Memory
1. Set the unit to the Channel Memory Mode by holding down FUNC key and pressing 7 FREQ/CH key until ‘M’
