To activate the programmed SET MODE, simply hold down FUNC key and press 4 MY key. The value of the settings
are changed by repeating the action. When Reset or All Reset are performed, the contents of this key return to the
memorized frequency step.
Using the Selector in Key Lock
When Key Lock is activated, all the keys except POWER/SQL OFF/SQL/VOLUME are locked. This function
additionally allows rotary selector to effective even when Key Lock is activated.
Hold down FUNC key and press 0 SET key.
Turn the selector to change the Set menu to display „OFF FLCH“. (Illust. 48-1)
Hold down FUNC key and turn the selector to change display from „OFF“ to „on“.
(Illust. 48-2)
To complete the setting, press CLEAR PROGRAM key.
Controlling the Squelch with RF Level (RF Squelch)
Instead of mechanical SQUELCH control, this function automatically sets the squelch level accordingly to the RF
signal strength measured by S-meter. SQL knob, therefore, disabled when this mode is in effect.
Hold down FUNC key and press 0 SET key.
Turn the selector to change the Set menu to display „OFFrFSqL“. (Illust. 49-1)
Hold down FUNC key and turn the selector to change the display from „OFF“ to any of RF signal strength
levels you want to set. (Illust.49-2)
To complete the setting, press CLEAR PROGRAM key.
Reducing Receiving Sensitivity (Attenuator)
This setting allows the receiver’s sensitivity to be reduced intentionally to avoid overloading and possible distortion
against very strong signal.
Hold down FUNC key and press 0 SET key.
Turn the selector to change the Set menu to display „OFF Att“. (Illust. 50-1)
Hold down FUNC key and turn the selector to change the display from „OFF“ to „on“.
(Illust. 50-2)
To complete the setting, press CLEAR PROGRAM key.
When this function is switched on, the ATT indicator lights continuously.
Receiving sensitivity is reduced by approximately 20 dB (when at 100 MHz) when this function is activated.
Changing the Proportion of Activation of the Signal Meter in FM Mode
This setting allows receiver to reduce signal level meter sensitivity in FM mode.
Hold down FUNC key and press 0 SETkey.
Turn the selector to change the Set menu to display „nor nFm-S“. (Illust 51-1)
Hold down FUNC key and turn the selector to change the display from „nor“ to „Lo“.
(Illust. 51-2)
To complete the setting, press CLEAR PROGRAM key.
Note:
l When this function is set on LO, .(dot) is displayed continuously at the lower right corder of the dispaly.
l This function does not operate when the reception Mode is set at WFM or AM.
l This function is most effectively used with attenuator to detect the source of signals such case as Fox Hunting.
