appears on the display.
2. Hold down FUNC key and press 7 FREQ/CH key once again.
3. Select the channel memory address to be erased by using the selector or numeric keys.
(Illust. 33-1)
4. Hold down FUNC key and press 9 L/OUT key. ( „CLr“ is displayed.) (Illust. 33-2)
5. Hold down FUNC key and press 9 L/OUT key once again to confirm deletion.
( A high pitched beep is emitted and the frequency is erased from search pass channel memory.)
6. To complete the procedure, press CLEAR PROGRAM key.
Note:
To cancel the operation, press CLEAR PROGRAM key before Step 5.
Scanning All Frequencies in Channel Memories (All Channel Scan)
This scans all frequencies stored in the channel memories.
1. Press 8 SCAN key while FUNC key is pressed . (Scan starts immediately) (Illust. 34)
2. To end, press CLEAR PROGRAM key.
During a scan, turning the Selector knob by one click, or holding down FUNC key and pressing the 5/ENT key, halts
the scan. The „SCN“ indicator in the display blinks.
Scan Specific Channel Memory Frequencies ( Memory Scan Memory) ;
This only scans channel memory locations specified.
Specifying channel Memory
Set the unit to the Channel Memory Mode by pressing FUNC and 7 FREQ/CH key simultaneously, ‘M’
appears on the display.
Set to the channel memory address specified by turning rotary knob or entering the channel number directly
using numeric keys. (Illust. 35-1)
Hold down FUNC key and press 0 SET key.
Turn the selector to change the set menu display to „OFF mSm“. (Illust. 35-2)
Hold down FUNC key and turn the selector to change the display from „OFF“ to „on“.
(The Down-arrow is displayed above the „M“. )
Press CLEAR PROGRAM key.
(The Down-arrow is displayed above the „M“ of the specified channel Memory address.)
(Illust. 35-3)
To specify other channel Memory address, repeat step 2 to 6.
To complete the procedure, press CLEAR PROGRAM key.
To Scan Only Specified Channels
Set the unit to the FREQ MODE by pressing CLEAR PROGRAM key.
Hold down FUNC key and press 0 SET key.
Turn the selector to change the set menu display to „OFF mSm“. (Illust. 36-1)
Hold down FUNC key and turn the selector to change the display from „OFF“ to „on“.
(The Down-arrow is displayed. )
Hold down FUNC key and press 8 SCAN key.
(Scan has been started.) (Illust. 36-2)
To end, press CLEAR PROGRAM key.
Note:
l To cancel the channel Memory Scan Memory, change the display from „on“ to „OFF“.
l During the all channel scan, press FUNC and 4 MY key simultaneously. Memory Scan Memory starts
immediately.
