Chapter 1 – Your First Session with the NanoVerb
10 NanoVerb Reference Manual
Placement and Installation
The NanoVerb may be mounted almost anywhere it's needed: on a table, on top of
an amp, next to a mixing console. In any case, make sure to place it safely where it
will not fall or be damaged. If it will be on furniture, make sure to attach the rubber
feet provided to the bottom of the unit. While the NanoVerb itself doesn't generate
any magnetic or hum fields, its power supply may do so. Make sure to place the
power supply away from other audio equipment that is sensitive to induced fields, and
away from the signal wiring. In rare instances, the NanoVerb itself may pick up noise
fields generated by other equipment such as large power amplifiers; in this case,
move the NanoVerb until the noise goes away.
Rack Mounting
The most secure mounting is on a "universal" rack shelf, available from various rack
manufacturers or your music dealer. The NanoVerb's height conforms to single-
space mounting, and up to three NanoVerbs may be mounted side-by-side in a
standard universal EIA 19" equipment rack.
A hole is pre-threaded in the base of the NanoVerb to attach it to a rack. Use an M5
x 6 screw (included) to fasten the NanoVerb to your rack tray. There is an end stop in
the screw hole to prevent longer screws from damaging the electronics.
