A SERVICE OF

logo

Open as PDF
next previous
Connections – Chapter 2
NanoVerb Reference Manual 17
Once the proper connection has been made, you must set the desired "wet/dry"
balance using the NanoVerb's [MIX] control. The [INPUT] and [OUTPUT] controls of
the NanoVerb should be set for unity gain: the volume when the Insert jack is
plugged in the mixer should be approximately the same as when the NanoVerb is out
of the circuit.
MIXER
INSERT
LEFT INPUT
LEFT OUTPUT
Using Main Outputs
When you want to add effects to everything on the mixer, you can connect the
NanoVerb between the mixer’s outputs and the amplifier’s or tape machine’s inputs.
This is done by using two 1/4" mono cables to connect the Left and Right Main
Outputs of the mixing console to the [LEFT/MONO] and [RIGHT] inputs of the
NanoVerb. The [LEFT] and [RIGHT] outputs of the NanoVerb are then connected to a
stereo amplifier, or two input channels of another mixing console (for sub-mixing
applications).