Connections – Chapter 2
NanoVerb Reference Manual 15
Mono In - Stereo Out. If you only want to feed the NanoVerb a mono input, but wish
to connect both of its outputs back to the mixer, you will need three 1/4" audio cables.
Connect a 1/4" phone cord from an effect send to the [LEFT] input of the NanoVerb,
another 1/4" phone cord from the [LEFT] output of the NanoVerb to an effect return or
other mixer input, and another 1/4" phone cord from the [RIGHT] output of the
NanoVerb to an adjacent effect return or mixer input. The Nanoverb creates a stereo
output, even though only a single input is used.
MIXER
AUX SEND 1
AUX RETURNS OR INPUT CHANNELS
LEFT INPUT
LEFT
OUTPUT
RIGHT
OUTPUT
Stereo In - Stereo Out. This connection is similar to the one described above.
However, by utilizing two sends from the mixer, we add one more cord and can now
send a stereo signal to the NanoVerb’s inputs. For example, if you connected sends
3 and 4 to the [LEFT] and [RIGHT] inputs, and had a stereo instrument (such as a
keyboard) connected to two channel inputs of the mixer (either one panned hard left
and hard right), you would send the left channel to send 3 and the right channel to
send 4. This is especially useful on the true stereo chorus program; on reverb and
delay programs only a mono input is needed.
MIXER
AUX SEND 1
AUX RETURNS OR INPUT CHANNELS
LEFT INPUT
LEFT
OUTPUT
RIGHT
OUTPUT
AUX SEND 2
RIGHT INPUT
How to Set Aux Send and Return Levels on the Mixer
