A SERVICE OF

logo

Unplug Lighting Switch
Unplug headlight and kill
button wiring here.
Disconnect headlight and kill
button grounds here.
Figure 1
Stator Wiring
5. Remove the kill switch. Unplug the black/white wire from the region below the tank and
remove the its ground from the ignition coil. Make sure to reinstall the coil and the remaining
ground wire.
6. Locate the AC voltage regulator found mounted to the frame just behind the engine on the left
hand side of the bike. It is a black finned aluminum box measuring approximately 1-1/4" x 2"
with two wires exiting it (Sorry no photo). Unplug the regulator from the wiring harness and
remove regulator.
4