SKU 94121 For technical questions, please call 1-800-444-3353. Page 9
To Install The Vise Assembly:
1. NOTE: Additional mounting holes at the rear of the Platform (35) allow for
adjusting the forward/backward location of the Vise assembly. (See Figure D.)
2. To install the Vise assembly, align the two mounting holes at the base of the Vise
assembly with two of the mounting holes located at the front of the Platform (35).
Then secure the Vise assembly to the Platform, using two Bolts (33), two Washers
(23), and two Nuts (30). (See Figure D.)
To Install The U-Clamps:
1. Tighten a Nut (19) on both threaded portions of a U-Clamp (8). Insert the
U-Clamp through the two mounting holes on the Platform (35). Then secure the
U-Clamp to the Platform, using two Lock Washers (20), and two Nuts (19).
Repeat this Step for the remaining U-Clamp. (See Figure D.)
To Install The Sliding Plate:
1. Place the Sliding Plate (36) over the inspection hole of the Platform (35), making
sure the Sliding Plate is properly positioned. (See Figure D.)
To Install The Ramp:
1. With assistance, lift the Ramp (37) and insert its two prongs into the two mount
ing holes located on the Platform. Secure the Ramp in place, using two Washers
(23) and two R-Pins (4). (See Figure D.)
2. Assembly is now complete. Remove the Locking Bar (22) from the Front
Lifting Arm (38). Then press down
slightly
on the Release Foot Pedal until the
Platform (35) is fully collapsed to the floor.
OPERATING INSTRUCTIONS
1. WARNING! Do not exceed the maximum lifting capacity of this tool
(1,000 pounds). Exceeding the maximum lifting capacities could cause personal
injury and/or property damage.
2. Make sure the Platform (35) is fully collapsed to the floor.
(See Figure E, next page.)
