Operation 7-13
Example 7–3 Show Config (Continued)
7 Acer Labs M1543C Bridge to Bus 1, ISA
15 Acer Labs M1543C IDE dqa.0.0.15.0
dqb.0.1.15.0
dqa0.0.0.15.0 COMPAQ CDR-8435
19 Acer Labs M1543C USB
Option Hose 0, Bus 1, ISA
Floppy dva0.0.0.1000.0
➓
PCI Box, Riser, Slot. Each PCI box in the system is identified by a
number (0 to F hexadecimal). A system can have a maximum of 16 PCI
boxes. The physical location of options in the PCI box are identifed by the
remote I/O riser (0 or 1), and slot number in the PCI box.
➀
Option. Options are listed. Note that the standard I/O module occupies
slot 1, on hose 0, riser 0, PCI box 0.
➁
Hose. PCI devices connect to logical hoses in the PCI box. A logical hose
number identifies the logical hose for each device. The firmware assigns
the logical hose number (0 to 63). Each PCI box has a maximum of four
logical hose numbers.
➂
Bus. The remote I/O riser PCI bus will always be numbered 0. Buses
behind device bridges are numbered 1, 2, 3, etc.
➃
Slot. This is the logical slot ID number of each device or controller.
➄
Function. On multi-function devices, the function ID is displayed.
➅
Name. Device names are listed.
➆
This next section of the show config output lists I/O devices by logical
order. The logical Slot number for each option appears in the first column.
➇
The Option name appears next.
➈
Hose 0, Bus 0, PCI. In this example, the standard I/O module is logical
Slot 1 on PCI Bus 0, Hose 0. See
➀ for a different presentation of this
information.
➉
The devices shown logically are the controllers and devices connected to
the controllers. COMPAQ BB00921B91 and RRD46 are SCSI drives
attached to controller pka0.
Continued on next page
