or recording a video in professional mode, the card of Class 10 is required.
Turn off the camera before inserting or removing the card.
2. Use the battery
2.1 Install the battery.
Please install the lithium battery correctly as shown in the following graphic.
!
!
Figure 1 Figure 2 Figure 3 Figure 4
Step 1. Push the battery cover switch to the lock position ( ), and remove
the battery cover. As shown in figure 1.
Step 2. Put the lithium battery into the battery slot. Make sure the electrodes of
the battery are corresponding to the symbols of the DV shell ( ). As shown
in figure 2 and figure 3.
Step 3. Install the battery cover back in place, and lock the switch to the lock
position ( ) to fix the battery. As shown in figure 4.
2.2 Charging the battery.
The camera uses a removable rechargeable lithium battery. When the camera
is off, connect it to a PC via USB cable to charge the battery. During
charging, the status indicator (blue) will light on, and will turn off when
the charging is complete.
Note: Connecting to a PC will not charge the camera if the camera is ON.
