Problem Solving
55
f The remote control does not work
f Mail is not received even if an abnormality occurs in the projector (EMP-6110 only)
Check Remedy
Is the remote control light-emitting area pointing towards the
remote receiver on the projector when it is operated?
Point the remote control towards the remote receiver.
The operating angle for the remote control is about 30° horizontally, and about 15° vertically. sQuick Start
Guide
Is the remote control too far from the projector? The operating range for the remote control is about 6 m. sQuick Start Guide
Is direct sunlight or strong light from fluorescent lamps
shining onto the remote receiver?
Set the projector up in a location where strong light does not shine onto the remote receiver. Or, set the
remote receiver to "Off" in "Remote Receiver" from the configuration menu. s"Settings"-"Remote
Receiver" p.33
Is the correct setting for the remote receiver selected? Check the "Remote Receiver" from the configuration menu. s"Settings"-"Remote Receiver" p.33
Are the batteries dead or have the batteries been inserted
correctly?
Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary. s p.61
Was a remote control button pressed for more than 30
seconds?
If any of the buttons on the remote control are pressed down for more than 30 seconds, the remote control
stops sending signals (remote control's sleep mode). This feature is to prevent the batteries running down if
the remote control buttons are held down accidentally such as when it is stored in a bag or if an object is
placed on top of it. When the button is released, normal remote control operation resumes.
Check Remedy
Is the LAN cable connected correctly? Check that the LAN cable is connected correctly. Reconnect it if it is not connected or it is not connected
correctly. s p.72
Is "Mail" set correctly in the configuration menu? Mail notification of abnormalities is sent according to the "Mail" settings in the configuration menu.
Check if it is set correctly. s"Network"-"Mail" p.38
Is "Standby Mode" set to "Network On"? To use the mail notification function when the projector is in standby, set "Network On" in "Standby Mode"
from the configuration menu. s"Extended"-"Standby Mode" p.36
Did a fatal abnormality occur and the projector come to a
sudden stop?
When it comes to a sudden stop, mail cannot be sent.
If the abnormal state continues, contact your local dealer or the nearest address provided in the Support and
Service Guide. s Epson Projector Contact List
Is power being supplied to the projector? Check that your electrical outlet or power source is functioning correctly.
