Replacing Consumables
63
f How to replace the lamp
A
After you turn off the projector's power and the
confirmation buzzer beeps twice, disconnect the
power cable.
B
Wait until the lamp has cooled down, then remove
the lamp cover from the surface of the projector.
Open the lamp cover by inserting the screwdriver supplied with the
new lamp into the lamp cover side switch, and remove the lamp
cover without removing the screwdriver.
Warning
When replacing the lamp because it has stopped illuminating, there
is a possibility that the lamp may be broken.
If replacing the lamp of a projector which has been installed on the
ceiling, you should always assume that the lamp is broken, and you
should stand to the side of the lamp cover, not underneath it.
Remove the lamp cover gently. Small pieces of glass may fall out
when the lamp cover is opened. If pieces of glass get into your eyes
or mouth, seek medical advice immediately.
Caution
Wait until the lamp has cooled down sufficiently before removing
the lamp cover. If the lamp is still hot, burns or other injuries may
result. It takes about one hour after the power has been turned off
for the lamp to be cool enough.
Procedure
