There are two methods for setting Wi-Fi Protected Setup.
• Push Button Method
SSID and security are set automatically when the [Enter] button is
pressed on the projector's control panel and the dedicated button on
the access point equipment. This method is recommended when the
projector and access point are close together.
• PIN Code Method
SSID and security are set automatically by inputting an 8-digit code that
was assigned to the projector from the computer to the access point in
advance. Make connection settings between the computer and the access
point in advance. For details on how to make this connection, refer to
the manual provided with the access point. This method is
recommended when the projector is mounted on the ceiling.
Connection Setup Method
Procedure
A
Press the [Menu] button, and then from the Configuration
menu select Network - Network Configuration.
The configuration screen is displayed.
B
Select Wireless LAN - To Setup Wizard.
The following screen is displayed.
When connecting using the Push Button Method, follow the steps
given below. To connect using the PIN Code Method
s "Connecting Using the PIN Code Method" p.109
Connecting to a Wireless LAN Access Point Using Wi-Fi Protected Setup (EB-1925W/1915 Only)
107
