A SERVICE OF

logo

B
Choose the ID you want to set and press the [Enter] button.
C
Press the [Menu] button to close the Configuration Menu.
Setting the Remote Control ID
Set the ID on the remote control each time you switch the projector
power on. When the projector is powered on, the remote controller ID
is set to "0" (i.e. you can operate the projector with the remote control
regardless of the projector ID).
Procedure
A
Point the remote control at the remote receiver of the
target projector and press the [ID] button on the remote
control.
Remote Control
When you press the buttons, the current Projector ID is displayed
on the projection screen. It disappears in about three seconds.
Limitation of the Number of the Target Projectors when Using Multiple Projectors
43