Setting Up the Projector 37
The indicator light above the slot comes on or flashes when the SD
card is in use. Do not remove the card when the light is flashing.
To remove the card, gently press the inserted SD card. The card
springs out, and you can then remove the card by pulling it straight
out.
Connecting a Network Cable
To connect the projector to your local area network (LAN), use a
commercially available 100BaseTX or 10BaseT network cable. To
ensure proper data transmission, use a Category 5 shielded cable or
better.
Connect the cable to the projector and your network port as shown:
Turning the Projector On and Off
Turn on any connected computer or video equipment before starting
the projector so it can automatically detect and display the image
source. If you turn on the projector first, or have multiple pieces of
connected equipment, you may have to select the image source
manually (see page 42).
caution
Do not remove the card
when the indicator light is
lashing, or you may damage
the card or projector.
LAN port
