Physical Port Settings
Enabling LLDP on a Port
config switch physical-port
set lldp-transmit [ enable | disable ]
next
end
Viewing LLDP Configuration
Use the following command to display the LLDPerrors:
get switch lldp errors
LLDP errors:
Total memory allocation failures: 0
Total unrecognized TLVs: 0
Use the following commands to display the LLDP information about the Layer 2 peers for a specified port:
get
switch
lldp
(neighbors-summary
| neighbors-detail)
<port>
Power over Ethernet
This section contains information on using Power over Ethernet (PoE) with your FortiSwitch.
Power over Ethernet is only available on the following models:
FS-108D-POE, FS-224D-POE, FSR-112D-POE,
FortiSwitch-108D-POE, FortiSwitch-124D-POE, FortiSwitch-224D-POE, and FortiSwitch-324B-
POE.
Enabling PoE on a Port
config switch physical-port
set poe-status enable
end
end
Determining the PoE Power Capacity
To determine the PoE power capacity, use the following command:
get switch poe inline
19
FortiSwitchOS-3.2.0
