CLI commands
WAN IP interface context
Path: View > Enable > Config > WAN IP interface
This context provides commands for configuring various IP-networking related settings.
pppoe client user
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
pppoe client user <username> <password>
Sets the PPPoE username and password.
no pppoe client user
Deletes the PPPoE username.
Parameters
<username> The username assigned to you by your ISP. The service controller will use
this username to log on to your ISP when establishing a PPPoE
connection.
<password> The password assigned to you by your ISP. The service controller will use
this username to log on to your ISP when establishing a PPPoE
connection.
ip address mode
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ip address mode (dhcp | pppoe | static | none)
Sets the IP addressing mode for Internet.
Parameters
dhcp Dynamic host configuration protocol. The DHCP server will automatically
assign an address to the service controller, which functions as a DHCP
client.
pppoe Point-to-point protocol over Ethernet. The PPPoE server will automatically
assign an IP address to the service controller. You need to supply a
username and password so the service controller can log on.
static This option enables you to manually assign an IP address to the service
controller.
none No IP address.
ip address
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ip address <ip address>/<mask>
Sets a static IP address for the port.
Parameters
<address> IP address.
</mask> Subnet mask in CIDR format. Specifies the number of bits in the mask.
2-79
