CLI commands
Access Controller context
Path: View > Enable > Config > Access Controller
All global access controller configuration takes place here.
end
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
end
Switches to parent context.
ads presentation
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ads presentation
Enable advertisement display at regular intervals for authenticated users.
no ads presentation
Disable advertisement display for authenticated users.
ads presentation interval
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ads presentation interval <number>
Control the advertisement display interval.
station allocate source ip address
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
station allocate source ip address
Allow dynamic IP addresses.
no station allocate source ip address
Disallow dynamic IP addresses.
Enable this option to provide network address translation for client stations with static IP
addresses. This permits the service controller to assign an alias address to the client that puts it on
the same subnet as the VSC the client is associated with. This option cannot be used if NAT is
enabled on the Internet port.
station allow any ip address
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
station allow any ip address
Enable this option to permit wireless client stations that are using a static IP address to connect to
the service controller, even if they are on a different subnet.
no station allow any ip address
Do not allow client stations with any IP addresses to connect.
2-49
