Expanding the OmniBook
Replacing Internal Hardware
3-3
Replacing Internal Hardware
This section describes how to
♦ Remove and install the hard-disk drive.
♦ Install a memory-expansion board.
Instructions on installing the battery are in chapter 1.
To replace the hard-disk drive
You normally don’t remove drive C, the main internal disk (also called the “hard-
disk drive”). The two main reasons to replace drive C are for upgrade and for repair.
If you do replace the hard-disk drive, be sure the new one also has “Drive Lock” hard-
drive security.
Back up your files before replacing the drive.
Take precautions against damage from static electricity. Gather all the parts
you need so you can complete the installation in one sitting. Don't remove the
drive from its packaging until you're ready to insert it.
When you remove the drive from its packaging, hold it only by its edges.
Turn off the computer, unplug the ac adapter, and remove the battery before
removing the hard drive. Otherwise, the OmniBook or the hard drive may be
1. Back up all the files on your current drive C. You can back up the files to a tape
drive, a network drive, a PC card, or a floppy disk. In Windows 95, use the
Backup utility (Start, Programs, Accessories, System Tools, Backup, Backup
tab). In Windows for Workgroups, you must back up individual files (File
Manager) or use a commercial backup program.
2. Important: Turn off the unit, unplug the adapter, and remove the battery.
