Chapter 1: Controls, Ports, and Indicators
2
Table 1-1. Control Panel Switch and Indicators
Control / Indicator Description
Power On/Off
This button turns the HP Server power On or Off. The
+12 V standby voltage is On whenever the server power
cords are plugged in.
Reset
When pressed, it resets the server and causes the power on
self-test (POST) to run.
INIT
When pressed, the system performs a crash dump provided
the dump is supported by the operating system.
System Power LED
(Green)
When lit continuously, it indicates the presence of DC
power in the server. When not lit, it indicates power is
turned off or the power source is disrupted.
Power Fail LED
(Amber)
When lit continuously, it indicates a power failure.
Fan Fail LED (Amber)
When flashing, it indicates a fan failure.
General Fault LED
(Amber)
When lit continuously, it indicates a hot plug PCI fault.
Front Panel LCD
It displays information about the processor type and the
POST codes.
