17-20 ELECTRICAL SYSTEM
Battery
Battery Removal
•
Turn off the ignition switch.
•
Remove:
Seat (see Frame chapter)
Battery Holder Bolts [A] and Collars
Battery Holder [B]
•
Disconnect the battery negative (–) cable [C] first, and
then the positive (+) cable [D].
•
Take out the battery [E].
Battery Installation
•
Turn off the ignition switch.
•
Install:
Rubber Dampers [A]
Clamp Nut [B]
•
Connect the positive cable first and then the negative.
•
Put a light coat of grease on the terminals to prevent cor-
rosion.
•
Install:
Battery Holder [C]
Collars [D]
Battery Holder Bolts [E]
Battery Activation
Electrolyte Filling
•
Make sure that the model name [A] of the electrolyte con-
tainer matches the model name [B] of the battery. These
names must be the same.
Battery Model Name for KVF750-A1: KMX 14-BS
CAUTION
Be sure to use the electrolyte container with the
same model name as the battery since the elec-
trolyte volume and specific gravity vary with the
battery type. This is to prevent overfilling of the
electrolyte, shorting the battery life, and deteriora-
tion of the battery performance.
