Fig. 12
u
Pull the plinth forwards to remove it. Possibly remove the
bottom door rack for easier installation.
u
Align the appliance by adjusting the feet so that it stands
straight: Extend the rear adjustable-height feet by turning
the screws
Fig. 12 (3)
. Extend the front adjustable-height
feet using a screwdriver, if they are fully retracted extend
them using an 8-mm Allen key. Appliance should be slightly
clamped in the recess, between floor and worktop!
Fig. 13
u
Insert foam element
Fig. 13 (8)
- functionally important for
separate air currents!
u
Re-attach the plinth and pull it forwards until the front edge
of the ventilation grille and the unit plinth are planar!
Fig. 14
u
Pay attention that the ventilation slots are unobstructed: If
necessary, cut away the plinth accordingly!
u
To fix the plinth: Insert the bolts
Fig. 13 (9)
, while keeping
firm hold of the plinth.
To secure appliance in the recess:
For installing the appliance under a granite worktop, a
fastening set for lateral fixation is available from After Sales
Service.
Fig. 15
u
Secure the appliance at the top using long Spax screws
Fig. 15 (19)
.
2.3.2 Fitting the unit door
Fig. 16
u
Check 8 mm presetting. (Distance between appliance door
and lower edge of crosspiece)
u
Push up assembly aids
Fig. 16 (12)
to unit door height.
Lower edge ▲of the assembly aid = top edge of the unit
door to be fitted.
u
Unscrew fastening crosspiece
Fig. 16 (11)
by undoing the
locknuts
Fig. 16 (10)
.
Fig. 17
u
Attach fastening crosspiece
Fig. 17 (11)
to the inside of the
unit door using the assembly aids
Fig. 17 (12)
.
u
Centre fastening crosspiece
Fig. 17 (11)
: mark a short
centre line on the unit door and place the tip of the cross-
piece arrow over it.
w
Distances to the outer edge are equal at the left and right.
For chipboard doors:
u
Secure the fastening crosspiece
Fig. 17 (11)
with at least 6
screws
Fig. 17 (19)
.
For frame and panel doors:
u
Secure the fastening crosspiece
Fig. 17 (11)
with 4 screws
Fig. 17 (19)
at the edge.
u
Raise the assembly aids
Fig. 17 (12)
for removal, turn them
and insert them into the adjacent openings.
Putting into operation
6
